Ableton Live - 9.0 Manual de usuario descargar pdf (Pagina 438)

100

101

438 Live Instrument Reference

Envelope Decay Time (Decay) — This sets the time it takes for an envelope to reach the sustain

level from the peak level. The shape of the decay can be adjusted via the Decay Slope (D.

Slope) parameter.

Envelope Sustain Level (Sustain) — This is the sustain level at the end of the envelope decay. The

envelope will stay at this level until note release unless it is in Loop, Sync or Beat Mode.

Envelope Release Time (Release) — This is the time it takes for an envelope to reach the end level

after a note-off message is received. The shape of this stage of the envelope is determined by

the Release Slope (R. Slope) value.

Envelope Initial Level (Initial) — This sets the initial value of the envelope.

Envelope Peak Level (Peak) — This is the peak level at the end of the envelope attack, and the

beginning of the Decay stage.

Envelope End Level (End) — (LFO, Filter and pitch envelopes only) This is the level reached at the

end of the Release stage.

Envelope Rates<Velocity (Time<Vel) — Envelope segments will be modulated by note velocity

as deﬁned by this setting. This is especially interesting if the envelopes are looping. Note that this

modulation does not inﬂuence the beat-time in Beat or Sync Modes, but the envelope segments

themselves.

Envelope Loop Mode (Loop) — If this is set to Loop, the envelope will start again after the end

of the decay segment. If set to Beat or Sync, it will start again after a given beat-time. In Sync

Mode, this behavior will be quantized to song time. In Trigger mode, the envelope ignores note

off.

Envelope Beat/Sync Rate (Repeat) — The envelope will be retriggered after this amount of beat-

time, as long as it is still on. When retriggered, the envelope will move at the given attack rate

from the current level to the peak level.

Envelope Loop Time (Time) — If a note is still on after the end of the decay/sustain segment, the

envelope will start again from its initial value. The time it takes to move from the sustain level to

the initial value is deﬁned by this parameter.

As mentioned above, Sampler’s envelopes also provide parameters that adjust the slope of their

envelope segments. Positive slope values cause the envelope to move quickly at the beginning,

then slower. Negative slope values cause the envelope to remain ﬂat for longer, then move

1 2 ... 433 434 435 436 437 438 439 440 441 442 443 ... 610 611

Comentarios a estos manuales

Sin comentarios

Ableton Live - 9.0 Manual de usuario Pagina 438

Comentarios a estos manuales

Relacionado con productos y manuales para Software Ableton Live - 9.0